-
Main public logs
Jump to navigation
Jump to search
Combined display of all available logs of Geekworm Wiki. You can narrow down the view by selecting a log type, the username (case-sensitive), or the affected page (also case-sensitive).
- 14:39, 17 August 2022 Lisa talk contribs uploaded File:X876-V1.1.jpg
- 11:18, 17 August 2022 Lisa talk contribs performed unknown action "comments/add" on X832 (Hello， Please refer to the instructions here to test X832 + HDD： How to check the X820)
- 11:28, 16 August 2022 Lisa talk contribs performed unknown action "comments/add" on X880 (Hello， Sorry，X880 does not support software safe shutdown.)
- 11:11, 11 August 2022 Lisa talk contribs performed unknown action "comments/add" on CM4 Stick (Hi， cm4 does not need a separate dts file, the official system is fine, because the interface does not need to be configured separately, you can operate the default mode)
- 10:59, 11 August 2022 Lisa talk contribs performed unknown action "comments/add" on NASPi Gemini (Hi， X882 does not have sleep mode, because many users request to turn off sleep mode so that the NAS can run stably.)
- 10:45, 11 August 2022 Lisa talk contribs performed unknown action "comments/add" on LVDS Adapter (Hi， It is a 4pin audio interface, please use the 4Pin cable)
- 10:42, 9 August 2022 Lisa talk contribs performed unknown action "comments/add" on X880 (Please use the same type of hard drive,HDD+HDD or SSD+SSD； an error will be reported when using SSD+HDD. If only 3.5inch disk of 8TB Toshiba is connected, do not connect other hard drives, can it boot normally？ PS：It is recommended to use an SD card to install the system.)
- 15:18, 8 August 2022 Lisa talk contribs performed unknown action "comments/add" on X880 (Hello， Did you test with only one hard drive（3,5 disk of 8TB Toshiba N300 NAS） connected? What power supply are you using?)
- 09:57, 6 August 2022 Lisa talk contribs performed unknown action "comments/add" on X715 (Hi， X715 not support Iqaudio Amp.)
- 10:09, 3 August 2022 Lisa talk contribs performed unknown action "comments/add" on NASPi (Hello， You can also use the spare acrylic sheet to replace the front panel of the case to reduce interference to WIFI)
- 10:48, 2 August 2022 Lisa talk contribs performed unknown action "comments/add" on PiKVM (1/The X630-A3 has an IS2 Audio In interface, which requires additional wiring to connect. 2/But currently the PIKVM system does not support audio. It depends on the system you are using. 3/The X630-A4 does not support audio.)
- 10:36, 1 August 2022 Lisa talk contribs performed unknown action "comments/add" on X-C1 Software (Hello， SW is only an external switch interface and cannot realize the auto power on function.)
- 10:31, 1 August 2022 Lisa talk contribs performed unknown action "comments/add" on X400 V3.0 (Hi， Headphone max output power: 142mW at 16Ω)
- 10:28, 1 August 2022 Lisa talk contribs performed unknown action "comments/delete" on X708-Hardware
- 10:28, 1 August 2022 Lisa talk contribs performed unknown action "comments/add" on X708-Hardware (Hi， We do not recommend this, please use the same specification of batteries.)
- 10:24, 1 August 2022 Lisa talk contribs performed unknown action "comments/add" on X708-Hardware (Hi， We do not recommend this, please use the same specification of batteries.)
- 10:22, 1 August 2022 Lisa talk contribs performed unknown action "comments/add" on X708 (Hi， We do not recommend this. Please use batteries of the same size.)
- 12:31, 29 July 2022 Lisa talk contribs performed unknown action "comments/add" on NASPi (Hi， Yes，X-C1 can power Pi4 via GPIO cable.)
- 11:48, 26 July 2022 Lisa talk contribs performed unknown action "comments/add" on X735 (Hello， X735 does not affect any USB ports.)
- 17:03, 25 July 2022 Lisa talk contribs performed unknown action "comments/delete" on PiKVM
- 17:02, 25 July 2022 Lisa talk contribs performed unknown action "comments/add" on PiKVM (Hi， We do not compare with IPMI. In addition, What is the price of IPMI? Most people don't just consider the solution and ignore the price. Of course, if you have enough budget, you can ignore its price.)
- 18:10, 19 July 2022 Lisa talk contribs performed unknown action "comments/add" on X735 (Yes, the higher the voltage, the lower the required current value. DC port ：it's positive center pin.)
- 17:52, 18 July 2022 Lisa talk contribs performed unknown action "comments/add" on PiKVM (Hi， It is a 2pin fan and does not support speed adjustment.)
- 17:52, 18 July 2022 Lisa talk contribs performed unknown action "comments/delete" on PiKVM
- 17:51, 18 July 2022 Lisa talk contribs performed unknown action "comments/add" on PiKVM (It is a normal 2pin fan and does not support speed adjustment)
- 11:08, 18 July 2022 Lisa talk contribs performed unknown action "comments/add" on X-C1 Software (Could you you provide more details? For example, the installed script, is there any error message？)
- 10:46, 18 July 2022 Lisa talk contribs performed unknown action "comments/add" on PiKVM (Hardware Real Time Clock (RTC) with CR1220 coin battery socket)
- 11:27, 16 July 2022 Lisa talk contribs performed unknown action "comments/add" on M200 (Hi， Is there any error message? Could you please tell us more specific information send some pictures or videos【support@geekworm.com】? And tell us your order number. thanks)
- 11:19, 16 July 2022 Lisa talk contribs performed unknown action "comments/add" on NASPi Gemini (There are two HDD indicator lights on the x882 board, you can observe the working status of the hard disk.)
- 16:14, 15 July 2022 Lisa talk contribs performed unknown action "comments/add" on NASPi Gemini (Hello， Raid 1 performance: both hard drives have the same data； One hard disk is the direct visible hard disk capacity, and the other hard disk is equivalent to the mirror hard disk. The data is written at the same time. When the visible hard disk is damaged, the mirror hard disk will automatically restore the complete data to the hard disk. About software operation, you can get more information on google. Best regards)
- 18:50, 12 July 2022 Lisa talk contribs performed unknown action "comments/add" on X820 (Hi，It may be caused by USB2.0 interference. But this is rarely encountered, and in most cases it can be used normally. You can try to use an USB3.0 cable instead of the bridge to test.)
- 17:48, 11 July 2022 Lisa talk contribs performed unknown action "comments/add" on X-C1 Software (Hi， Is there any error message? Or you can try to reinstall the system to test it.)
- 14:54, 11 July 2022 Lisa talk contribs performed unknown action "comments/add" on X708 (Hi, We can provide PCB size pictures, but can't provide schematic diagrams)
- 12:28, 11 July 2022 Lisa talk contribs performed unknown action "comments/add" on X400 V3.0 (Hello， Could you please send a test video to [support@geekworm.com];and let us known your order No. ; Thanks)
- 12:27, 11 July 2022 Lisa talk contribs performed unknown action "comments/delete" on X400 V3.0
- 12:27, 11 July 2022 Lisa talk contribs performed unknown action "comments/add" on X400 V3.0 (Hello， Could you please send a test video to [support@geekworm.com];and let us known your order No. ; Thanks)
- 09:20, 8 July 2022 Lisa talk contribs performed unknown action "comments/add" on X-C1 Software (Hi， What version is your X-C1? X-C1 v2.0 added Fan FS jumper, please check if the Fan FS jumper cap is shorted.)
- 16:32, 7 July 2022 Lisa talk contribs performed unknown action "comments/add" on X735 Software (Jumper No. function please refer X735 Hardware)
- 15:56, 6 July 2022 Lisa talk contribs performed unknown action "comments/add" on C779 (Hello， This chip TC358743 supports up to 8bit 444)
- 11:47, 6 July 2022 Lisa talk contribs performed unknown action "comments/add" on X735 Software (Hi， ①Please check if the Fan FS jumper cap is shorted. ②The installation script restarts running sudo python3 read_fan_speed.py, is it possible to read the fan speed?)
- 16:09, 4 July 2022 Lisa talk contribs performed unknown action "comments/add" on X735 Software (Hi, Sorry, it is not supported yet. you can remove the FAN FS jumper, the PWM fan will run at full speed.)
- 15:59, 4 July 2022 Lisa talk contribs performed unknown action "comments/add" on X880 (Hi， 1）you can use only 1HDD. 2）you can buy a 12V 5A PSU fromeGeekworm store:https://geekworm.com/products/dc-5-5x2-5mm-12v-5a-power-supply-eu-us-plug?_pos=5&_sid=93dab9716&_ss=r)
- 15:59, 4 July 2022 Lisa talk contribs performed unknown action "comments/delete" on X880
- 15:59, 4 July 2022 Lisa talk contribs performed unknown action "comments/add" on X880 (Hi， 1）you can use only 1HDD. 2）you can buy a 12V 5A PSU fromeGeekworm store:https://geekworm.com/products/dc-5-5x2-5mm-12v-5a-power-supply-eu-us-plug?_pos=5&_sid=93dab9716&_ss=r)
- 15:57, 4 July 2022 Lisa talk contribs performed unknown action "comments/delete" on X880
- 15:56, 4 July 2022 Lisa talk contribs performed unknown action "comments/add" on X880 (Hi， 1）you can use only 1HDD. 2）https://geekworm.com/products/dc-5-5x2-5mm-12v-5a-power-supply-eu-us-plug?_pos=5&_sid=93dab9716&_ss=r)
- 15:11, 4 July 2022 Lisa talk contribs performed unknown action "comments/add" on X400 V3.0 (Hi， Yes，due to the raspberry pi USB 3.0 frequency interference, it is recommend to use 5G AP if use the case)
- 15:07, 4 July 2022 Lisa talk contribs performed unknown action "comments/add" on X400 V3.0 (Hi， Power supply: 6-26Vdc，( >=3A is recommend))
- 14:50, 29 June 2022 Lisa talk contribs performed unknown action "comments/add" on X920 (Hi， please refer X950 software#Moode Audio Player)
- 10:58, 25 June 2022 Lisa talk contribs performed unknown action "comments/add" on X852 (Hi， X852 supports Pi4 if you use USB3.0 cable)
