P165: Difference between revisions

Line 17:

'''Why is it compatible with the pi 4 expansion boards?'''

# The P165~~~~(P165-A ~~2026 Ver.~~)~~~~ Embedded Armor Aluminum Alloy Heatsink ~~stands 8mm~~ high with a negative tolerance ~~design, and comes~~ with M2.5*5+5 copper spacers ~~for a~~ total ~~assembled~~ height of 12mm~~. This setup is compatible with~~ most Raspberry Pi 4 expansion boards (~~excluding~~ PoE expansion ~~boards~~); ~~simply~~ replace the copper spacers with ~~ones of~~ the ~~correct~~ height ~~for fitting other-sized expansion boards~~. ~~Contact us directly if~~ you ~~require custom-~~height copper spacers~~.~~

# The P165(P165-A) Embedded Armor Aluminum Alloy Heatsink Radiator is 7mm high, which is designed with negative tolerance. And it is equipped with M2.5*5+5 copper spacers; so the total height is 12mm, which can support most of Raspberry Pi 4 expansion boards(not support PoE expansion board); if you use expansion board with other height, you only need to replace the copper spacers with the right height. (If you need a special height copper spacers, please contact us.)

~~# The raspberry pi hat positioning hole has internal thread for easy fixing from above or below; Compared to the raspberry pi PCB~~, ~~the entire heat sink shrinks inward by 0.5 mm~~.

'''Why design this new P165-B 11mm heatsink?'''

@@ Line 17: / Line 17: @@
 '''Why is it compatible with the pi 4 expansion boards?'''
-# The P165<span class="tb_red">(P165-A 2026 Ver.)</span> Embedded Armor Aluminum Alloy Heatsink stands <span class="tb_red">8mm</span> high with a negative tolerance design, and comes with M2.5*5+5 copper spacers for a total assembled height of 12mm. This setup is compatible with most Raspberry Pi 4 expansion boards (excluding PoE expansion boards); simply replace the copper spacers with ones of the correct height for fitting other-sized expansion boards. <span class="tb_red">Contact us directly if you require custom-height copper spacers.</span>
+# The P165(P165-A) Embedded Armor Aluminum Alloy Heatsink Radiator is 7mm high, which is designed with negative tolerance. And it is equipped with M2.5*5+5 copper spacers; so the total height is 12mm, which can support most of Raspberry Pi 4 expansion boards(not support PoE expansion board); if you use expansion board with other height, you only need to replace the copper spacers with the right height. (If you need a special height copper spacers, please contact us.)
-# The raspberry pi hat positioning hole has internal thread for easy fixing from above or below; Compared to the raspberry pi PCB, the entire heat sink shrinks inward by 0.5 mm.
 '''Why design this new P165-B 11mm heatsink?'''