|
|
| Line 102: |
Line 102: |
| :*Remove the nBOOT jumper after the flashing is complete, then restart your device. | | :*Remove the nBOOT jumper after the flashing is complete, then restart your device. |
| '''Note''': For CM4 with eMMC, the SD card cannot be used. | | '''Note''': For CM4 with eMMC, the SD card cannot be used. |
|
| |
| #CM4 without eMMC (simpler, but you need a 32GB or 64GB micro sd)
| |
| :''' 1) How to installing the Operating System''' (CM4 without eMMC)
| |
|
| |
| :Refer to [https://www.raspberrypi.com/documentation/computers/getting-started.html#installing-the-operating-system Official installation tutorial]
| |
|
| |
| :'''2) How to flash OS onto the eMMC of CM4? (CM4 with eMMC)'''
| |
|
| |
| ::a. Short nBOOT&GND, refer to the picture below.
| |
|
| |
| ::[[File:X650-IMG-5474-1.jpg|500px]]
| |
|
| |
| ::b. Connect Type-C OTG to your computer
| |
|
| |
| ::c. Power the X650 via PWR Type-C with your 5V Power adaper
| |
|
| |
| ::d. Then rerfer to [https://www.jeffgeerling.com/blog/2020/how-flash-raspberry-pi-os-compute-module-4-emmc-usbboot this tutorial] to flash pikvm OS
| |
|
| |
| ::e. Remove the jumper of nBOOT&GND after flashing is complete, then restart your device;
| |
|
| |
| 4. Power the device, then open explore to login the pikvm web ui.
| |
|
| |
|
| ===Enable RTC === | | ===Enable RTC === |