Difference between revisions of "P579"

Latest revision as of 12:08, 22 August 2024

P579-V2 view

P579-V2 bottom view

P579 bottom view

Installation introduction

Overview

The biggest reason for its creation is to support the top PCIE to M2 NVME shield. Apart from this, even if you don't have a PCIE to M2 NVME board now, it is also compatible with Raspberry Pi 5 and Raspberry Pi 5 Official Active Cooler, but a PCIE to M2 NVME boards like X1000, X1001, X1003 or X1004 is recommended.

The P579 is not only suitable for Geekworm PCIe to NVMe SSD series boards, but also compatible with third-party PCIe to NVME boards. The unique cut-out design on the front of the case also meets the LED display requirements of most third-party PCIe to NVME boards, and the only thing you need to pay attention to is the height of the copper posts used by third-party PCIe to NVME boards, which is no more than 17mm in height.

But please note: since X1002 is a bottom PCIE to M2 NVME shield, so P579 is not compatible with X1002, but you can look forward to our P580 case, which is specially designed for X1002.

[NOTE]

Based on customer feedback, we updated P579 and renamed it P579-V2 on March 2024. P579-V2 is only 5mm taller than P579, there will be more space between the top cover and the NVME board which is helpful for some specific thicker NVME SSDs for mounting an SSD cooler, and the P579-V2 is also compatible with the X1004 shield but the P579 is not.Only P579-V2 will be produced later.

Features

Model: P579
Compatible with Raspberry Pi 5
Compatible with Raspberry Pi 5 official cooler
Compatible with X1000, X1001, X1003, X1004, X1015, X1012, M400, M300, Q100, Q200, M901
Easy to install, excellent heat dissipation

Packing List

1 x Metal case P579
4 x M2.5x5+5mm spacers
4 x M2.5x6Ø4mm copper nuts
4 x KM2.5x4mm screws
1 x 4pcs rubber pads

Assembly instructions

Enable comment auto-refresher

Anonymous user #5

8 months ago

Score 0

I bought the P579. I already owned the x1001 and the Pi5 had the active cooler. This is

a great combination case which I highly recommend.

Permalink | Reply

Anonymous user #3

8 months ago

Score 0

bought P579 case and shield for it. Went together fine, waiting on drive so have no comments on operation.

Was there or is there going to be a sw cover for the pi power sw. Using a fingernail now to operate it and it is exposed to dust and quite delicate.

Permalink | Reply

Lisa

8 months ago

Score 0

Hi,We also considered this issue when designing P579/P580 Case, but it is difficult to implement. If you have any good switch ideas, please recommend them to us.Thanks

Permalink

Anonymous user #2

9 months ago

Score 0

To what extent does this P579 case reduce WiFi and Bluetooth signal strength?

Permalink | Reply

Walker

9 months ago

Score 0

Metal cases generally have some degree of impact on WiFi and Bluetooth

Permalink

Anonymous user #4