Recent changes
Jump to navigation
Jump to search
Track the most recent changes to the wiki on this page.
List of abbreviations:
- N
- This edit created a new page (also see list of new pages)
- m
- This is a minor edit
- b
- This edit was performed by a bot
- (±123)
- The page size changed by this number of bytes
10 June 2024
| 09:36 | Comments log 174.174.80.39 talk posted a new comment on X1200 (Is it possible to change the auto shutdown behavior to turn the raspberry pi off after a certain amount of time on battery rather than when the battery is low?) | ||||
9 June 2024
|
|
22:54 | (Comments log)[60.53.223.148; 75.135.187.128; 97.80.188.124 (2×)] | |||
|
|
22:54 75.135.187.128 talk posted a new comment on H402 (1) It would be helpful to have the numbers on the thermal pads in step 3 copied over to the Packing List image. (I believe it should be 3, 2, 1, 4, 5 from left to right in the Packing list image.) 2) Add a note to remove the clear plastic film from both sides of the thermal pads or they're not going to work.) | ||||
|
|
13:00 97.80.188.124 talk posted a new comment on X-UPS1 (For the external switch the description on the PCB says power(black), Gnd(red), Gnd(yellow), and SW(blue) In that exact order on a psw19 or any 4 prong switch you have positive, negative, NO, and C Please show wire diagram for of the PH2.0 signal cable connector and the external momentary switch) Tags: Mobile web edit, Mobile edit | ||||
|
|
12:58 97.80.188.124 talk posted a new comment on X-UPS1 (For the external switch the description says power(black), Gnd(red), Gnd(yellow), and SW(blue) In that exact order on a psw19 or any 4 prong switch you have positive, negative, NO, and C Pleasure show wire diagram for of the PH2.0 signal cable connector and the external momentary switch) Tags: Mobile web edit, Mobile edit | ||||
|
|
00:10 60.53.223.148 talk posted a new comment on X708 (Hi, the auto on after power failure is not working consistently. To power on sometimes I need to unplug the USB C power cable and re-plug. Please note that I have consistently: 1) Waited a few minutes after the battery indicator light is off - a long as 5 minutes, there is no way the USB plug is still providing power. 2) USB plug is disconnected from mains. Thanks in advance) | ||||
8 June 2024
| 13:20 | Comments log 67.87.242.156 talk posted a new comment on CSI Manual on Pi 5 (Anyway to get Chrome/Firefox to recognize it as a webcam? I've tried piping the video through workarounds where you can pipe the video to v4l2loopback, but that was exceptionally slow.) | ||||