5,251
edits
Changes
Jump to navigation
Jump to search
1. # Enable PCIe to make nvme ssd work, please refer to [[NVMe SSD boot with the Raspberry Pi 5]] 2. # Tell the Pi that the X1012 POE is capable of 5A, so the USB current will get the full 1.6A
Save and exit[[File:X1012-setting. In nanopng|700px]] Press Ctrl-O, then enter, you do that by hitting CTRL + to write the change to the file. Press Ctrl-X, answering Y and hitting Enter when promptedto exit nano (the editor).
* Hardware Installation： [https://suptronics.com/Raspberrypi/Storage/x1012-v1.2_hardware.html X1012 Hardware]
* Configuration Tutorial：
sudo rpi-eeprom-config -e
Add PSU_MAX_CURRENT=5000 at the end of the file that reads like this:
Reboot your Raspberry Pi 5 to make the change take effect.
* Introduction to Implementing Auxiliary Power on POE: [[File:AN3472-Implementing-Aux-Power-in-PoE.pdf]]