393
edits
Changes
Jump to navigation
Jump to search
Power supply＊'''Warning''' : 5Vdc +/-5% Please backup your data before setup and switch, ≥4Aotherwise you maybe lost your data.
Ports & Connectors1. Install the HDDs 2. Please connect the X880 to your PC or Raspberry Pi board and keep power on 3. Switch RAID mode* Set the switch button to your preferred RAID mode(PM/RAID 0/RAID 1/SPAN) as per the RAID illustration table.* Press the '''SET''' button for about 5 seconds, and release it till the blue LED indicators starts flashing.* After RAID mode changed, please confirm that the PC can recognize the disk(s) properly and shows the right capacity. or you can run the fdisk -l command to view the hard drive on raspberry pi OS when you connect x880 to raspberry pi board: Type C; DC jack fdisk - lYou can found two hard drives if you select 'clear raid mode'(this is PM model) or You found only one hard drive if you select the RAID0/RAID1 model 4. Set CLEAR RAID mode (PM, factory default setup) * Press the SET button for about 5seconds then and release it till blue LED indicators starts flashing.5x2* After above processes, the setup for CLEAR RAID is done.1mm;
X882
,|}
==Power Supply RequirementRaid setup==Dual 2.5-inch hard drives require high quality power supply, or the HDD/SSD may cannot be recognized.【RAID setup and Jumper setting】
==Packing List==