CommentStreams:724713a09ee3e02d4e836df13627890c

Hi I tried to connect battery low led to external PH2.0 connector but it seems like it does not light up when battery low blinks on the board and when i run continuity test on that connector (when board is off) there is a short between pins 2 and 3 to ground. I have X708 v2.0, is this my board's fault or schematic has changed for external power switch? It seems like it was reworked to adapt for 4 pin momentary switch with led light (so pins go like this power on/gnd/gnd/power led)