5,152
edits
Changes
Jump to navigation
Jump to search
X880
,1. Install the HDDs
2. Please connect the X880 to your PC or Raspberry Pi board and keep power on.
3. Switch RAID mode
* Set the switch button to your preferred RAID mode(PM/RAID 0/RAID 1/SPAN) as per the RAID illustration table.
* Press the '''SET ''' button for about 5 seconds, and release it till the blue LED indicators starts flashing.
* After RAID mode changed, please confirm that the PC can recognize the disk(s) properly and shows the right capacity.
or you can run the fdisk -l command to view the hard drive on raspberry pi OS when you connect x880 to raspberry pi board:
fdisk -l
You can see the two hard drive if you clear raimd mode(this is PM model)
or
You can sell only one hard drive if you select the RAID0/RAID1 model
4. Set CLEAR RAID mode (PM, factory default setup)