Difference between revisions of "X635-Software"
Jump to navigation
Jump to search
| Line 15: | Line 15: | ||
[[File:X635-software-15.png|700px]] | [[File:X635-software-15.png|700px]] | ||
| − | X635-software-18.png | + | Note: You should get back <big>supported=1, detected=1</big>, indicating that the CSI-2 bridge is detected and supported by the operating system. If you get detected=0, then the CSI-2 bridge is not being seen by the operating system. |
| + | |||
| + | [[File:X635-software-18.png|700px]] | ||
<!--Add review function! --> | <!--Add review function! --> | ||
Revision as of 19:35, 24 April 2023
X635 Software Guide base on Raspberry Pi OS bullseye
1. To use the HDMI to CSI-2 bridge, you will need to enable Enable legacy camera support.
3. Again open a terminal window and type the following command:
sudo wget https://datasheets.raspberrypi.org/cmio/dt-blob-cam1.bin -O /boot/dt-blob.bin #Download the required file /boot/dt-blob.bin
4. Reboot for the dt-blob.bin file to be read
sudo reboot
5. Open the Terminal and run the command to check if the HDMI to CSI-2 bridge is being seen by the operating system.
Note: You should get back supported=1, detected=1, indicating that the CSI-2 bridge is detected and supported by the operating system. If you get detected=0, then the CSI-2 bridge is not being seen by the operating system.
Enable comment auto-refresher