Difference between revisions of "X630-Hardware"
Jump to navigation
Jump to search
(Created page with "center 10-pin functional connector {| class="wikitable" ! Pin No. !! Pin Name !! Function !! Note |- | 1 || 3V3 || 3.3V output || 3.3V |- | 2 ||...") |
|||
| Line 1: | Line 1: | ||
| − | [[File:X630-diagram.png | + | [[File:X630-diagram.png]] |
| − | |||
| − | |||
| + | ==10-pin functional connector== | ||
{| class="wikitable" | {| class="wikitable" | ||
! Pin No. !! Pin Name !! Function !! Note | ! Pin No. !! Pin Name !! Function !! Note | ||
| Line 27: | Line 26: | ||
|} | |} | ||
| − | X630 Reset Setting | + | ==X630 Reset Setting== |
{| class="wikitable" | {| class="wikitable" | ||
! SELECTION !! SWITCH SETTINGS !! | ! SELECTION !! SWITCH SETTINGS !! | ||
Revision as of 12:09, 23 September 2021
10-pin functional connector
| Pin No. | Pin Name | Function | Note |
|---|---|---|---|
| 1 | 3V3 | 3.3V output | 3.3V |
| 2 | HDET | HDMI input detect (high level ) | 3.3V |
| 3 | IR | Infrared signal | 3.3V |
| 4 | INT | Interrupt Output signal – active high (Level) | 3.3V |
| 5 | RESET | System reset input, active low | 3.3V |
| 6 | A_SCK | I2S/TDM Bit Clock signal (BCK) | 3.3V |
| 7 | A_WFS | I2S Word Clock or TDM Frame Sync signal (LRCK) | 3.3V |
| 8 | A_OSCK | Audio Oversampling Clock (MCLK) | 3.3V |
| 9 | A_SD | I2S/TDM data signal (Data) | 3.3V |
| 10 | GND | Ground | 0V |
X630 Reset Setting
| SELECTION | SWITCH SETTINGS | |
|---|---|---|
| Hardware reset | HW = 1 | SW = 0 |
| Software reset | HW = 0 | SW = 1 |
Hardware reset: After starting RASPISTILL or RASPIVID once then you will need to reboot Raspberry Pi to restart it again
(Please use when operating system cannot control the X630 module via GPIO509)
Software reset: Starting RASPISTILL or RASPIVID multiple times and don't need to reboot Raspberry Pi