2,853
edits
Changes
Jump to navigation
Jump to search
T208
,==Features==
FOR USE WITH
- Jetson Nano
OPERATING SYSTEM
- All operating systems
KEY FEATURES
Smart and powerful Uninterruptible Power Supply (UPS)
- Provides continuous operations for up to 10~30hours (depending on battery type and qty used)
- Max 5.1V 8000mA Power Backup for even the most demanding Jetson Nano set ups
- 6-cell 18650 lithium Ion holder
- Can work with 1/2/3/4/5/6 18650 lithium Ion batteries
- Supports 3A fast battery charging
- Integrated battery protection circuit
- Integrated over current protection and over voltage protection
- Integrated Maxim's fuel-gauge systems (Reading battery voltage and percentage via i2c)
- Integrated TI's 10-A fully-integrated synchronous boost converter
- Intelligent automatic charging and discharging
- On-board 4 green LEDs indicate battery charging and discharging levels of 25%, 50% , 75% and 100%
- On-board blue LED show the status of power on/off
Intelligent and safe power management
- On-board push button to control power on /off
(Press-ON, Hold the button pressed at least 3s -OFF)
- AC power loss or power adapter failure detection (LED and GPIO indication)
- Automatic powering off after system shutdown using the GUI
- Optional to enable Auto power on when power applied or restored
- Ultra-low standby power consumption of μA to maximize battery life
- Integrated IN-to-SYS pass-through path to pass the input voltage to the system
- Operate in both charge mode and boost mode to allow full system management and battery power management
- Advanced system power path management avoids frequent charging and extend battery life
- Advanced system power path management allows 3A fast charging and powering Jetson Nano at the same time
- Powers the Jetson Nano via the 40-pin header - no additional cabling required
- Power input jack (5.5*2.5mm) and XH2.54 connector convenient for power input
- On-board PH2.0 connector allows to connect external power switch and DIY your perfect case
- On-board XH2.54 power output connectors allow to power other devices
- Mounting holes and standoffs provide mechanical stability of the Jetson Nano and T208 assembly
SPECIFICATION
- Power input : 5Vdc ±5%, ≥4A
- UPS output : 5.1V ±5% Max 8A
- UPS charging current: 2A via Micro-USB socket, 3A via DC jack
-
Terminal Battery Voltage : 4.24V
-
Recharge Threshold : 4.1V
NOTES
- Do not apply power to your Jetson Nano via the Micro USB socket or power jack.
- Do not use 18650 battery with built-in protection circuit
==Packing List==