Related changes
Jump to navigation
Jump to search
Enter a page name to see changes on pages linked to or from that page. (To see members of a category, enter Category:Name of category). Changes to pages on your Watchlist are in bold.
List of abbreviations:
- N
- This edit created a new page (also see list of new pages)
- m
- This is a minor edit
- b
- This edit was performed by a bot
- (±123)
- The page size changed by this number of bytes
5 May 2024
| 11:07 | Comments log 98.177.143.149 talk posted a new comment on X1003 (Micron 250GB 2242 MTFDKCD256TFK worked for me with the X1003 after updating eeprom.) | ||||
4 May 2024
|
|
18:17 | (Comments log)[84.170.25.179 (2×)] | |||
|
|
18:17 84.170.25.179 talk posted a new comment on X1201 (Seems to be MAX17048 and does not support much more info (no shunt)) | ||||
|
|
18:13 84.170.25.179 talk posted a new comment on X1201 (What is the battery fuel gauge ic partnumber? Does it support more info than the current voltage?) | ||||
3 May 2024
| 22:55 | Comments log 80.74.161.124 talk posted a new comment on X1011 (Not so interesting without good case) | ||||
2 May 2024
| 10:09 | Comments log 69.174.137.7 talk posted a new comment on X857 V2.0 (blue led light indicates?) | ||||
30 April 2024
|
|
16:57 | (Comments log)[193.191.241.17 (2×)] | |||
|
|
16:57 193.191.241.17 talk posted a new comment on X1008 (Is there a compatible case for this ?) | ||||
|
|
16:51 193.191.241.17 talk posted a new comment on X1011 (Which model of DC power is compatible ?) | ||||
28 April 2024
| 14:00 | Comments log 24.128.44.197 talk posted a new comment on X1001 (The XH2.54 5V power connector connects to the GPIO on the Raspberry Pi 5?) | ||||
26 April 2024
| 12:40 | Comments log 74.111.99.142 talk posted a new comment on X450 (Can the 3.5mm headphones jack be used as output as well?) | ||||
25 April 2024
| 02:55 | Comments log 73.22.53.193 talk posted a new comment on X1011 (I would like to create a NAS, Raid 5 out of this, are you planing to release instructions to do so?) | ||||
24 April 2024
|
|
16:57 | (Comments log)[77.189.215.199; 185.65.135.178] | |||
|
|
16:57 185.65.135.178 talk posted a new comment on X1001 (Integrated with XH2.54 5V power connector. It is, but what is not supplied or offered is a short cable to connect to the Pi5 board. And yes, my Pi5 is working great with the X1001 and a 1TB 2280 SDD. The dtparam=pciex1_gen=3 has been set and the microSD has been removed. So I don't really need the extra power connector, but it should have been included anyways just to be on the safe side.) | ||||
|
|
04:08 77.189.215.199 talk posted a new comment on X1002 (Crucial P3 Plus 500 GB works after update to eeprom firmware 2024 - 04 - 20) | ||||
23 April 2024
| 02:47 | Comments log 136.23.0.128 talk posted a new comment on X1011 (I would also like a case produced. Thanks) | ||||
22 April 2024
|
|
05:33 | (Comments log)[177.99.103.158; 108.76.201.4 (2×)] | |||
|
|
05:33 108.76.201.4 talk posted a new comment on X1001 (I posted as anon user #15 earlier. I think I got the problem resolved by routing the cable a little differently. I noticed I did not have the problem if the device was outside of the case (Geekworm P579-V2-K). I tried adding some electrical tape to the inside of the case (per Q4), but that didn't make a difference. However, I noticed that, when the pi was installed in the case, the FCC cable was being pressed against the inside of case, which caused it to bend some and appeared to cause...) | ||||
|
|
04:04 177.99.103.158 talk posted a new comment on X1001 (Is there a way to disable the LED light, its so annoying.) | ||||
|
|
01:14 108.76.201.4 talk posted a new comment on X1001 (I've installed the X1001 with a 128GB Silicon Power P24A60 (Model A60), and it has booted and ran fine for at least an hour or so, then everything just stops responding and basic commands like sudo and ls are no longer found. It behaves as though the drive has being disconnected, but the blue light is still on when this happens. I have re-seated the FCC cable on both ends a few times. It seems to be seated fully and securely. Also, the drive is typically recognized (at least momentarily)...) | ||||