Geekworm Wiki

Raspberry pi 0.91 inch OLED Module SKU:385011

Revision as of 18:37, 29 April 2026 by Harry (talk | contribs)
Raspberry pi 0.91 inch OLED Module sku:385011
Raspberry pi 0.91 inch OLED Module sku:385011

Instruction

Stacking 0.91" OLED Module for Raspberry Pi / Arduino / Banana PI / PCDuino (128 x 32). 0.91 inches 128x32-resolution OLED display, high-speed, low-power, programmable and flexible configuration and so on.

Features

  • Support 3.3V/5V two kinds of power supply (toggle via switch).
  • Data input/output via the I2C bus, compatible with 3.3V/5V level (toggle via switch).
  • Resolution: 128x32.
  • Can be used independently, can also be used with our Cascading and Overlapping Multi-Function Sensor Expansion Board(sku. 357254)
  • Compatible with raspberry pie(Raspberry pi 2 Model B / B+ / B / A+), banana pie, cubieboard, pcduino, Arduino etc.

Packing List

  • 1 x OLED Module

Application

Stacking 0.91" OLED Module can used with board Cascading and Overlapping Base Board SKU:357254

How to connect

Compeletely compatible with Arduino and Raspberry Pi 

             Module Pin Connections
Sensor module => Arduino Sensor module => Raspberry Pi
SCL --> A5 SCL --> SCL
SDA --> A4 SDA --> SDA
GNO --> GNO GNO --> GNO
IRQ --> D2 IRQ -->GPIO
VCC --> 5V VCC --> 3.3V
  • Enable I2C interface of Raspberry PI, can be configured via the raspi-config configuration tool or edit the file /boot/config.txt, add line:
 dtparam=i2c_arm=on
  • Add I2C modules,edit /etc/modules file (command: sudo nano /etc/modules) , append the following lines:
 i2c-bcm2708
 i2c-dev
  • Installing the I2C library and tools
 sudo apt-get install i2c-tools python-smbus
  • Update software and install the RPI.GPIO library
 sudo apt-get update
 sudo apt-get install build-essential python-dev python-pip
 sudo pip install RPi.GPIO
  • Install graphic library
 sudo apt-get install python-imaging python-smbus
  • Download some software libraries, then run
 sudo apt-get install git
 git clone https://github.com/adafruit/Adafruit_Python_SSD1306.git
 cd Adafruit_Python_SSD1306
 sudo python setup.py install
  • Provide three samples (animate.py, image.py,shapes.py)
 cd Adafruit_Python_SSD1306
 sudo python shapes.py

Note: when using the sensor base plate, OLED on the left and right side interfaces using the RST PIN isdifferent, around 25# and 24# respectively, modify the corresponding pin on the line, the default is the right <comments/>

Retrieved from "https://wiki.geekworm.com/index.php?title=Raspberry_pi_0.91_inch_OLED_Module_SKU:385011&oldid=29354"