X635-Software
Jump to navigation
Jump to search
X635 Software Guide base on Raspberry Pi OS bullseye
1. To use the HDMI to CSI-2 bridge, you will need to enable Enable legacy camera support.
3. Again open a terminal window and type the following command:
sudo wget https://datasheets.raspberrypi.org/cmio/dt-blob-cam1.bin -O /boot/dt-blob.bin #Download the required file /boot/dt-blob.bin
4. Reboot for the dt-blob.bin file to be read
sudo reboot
5. Open the Terminal and run the command to check if the HDMI to CSI-2 bridge is being seen by the operating system.
Note: You should get back supported=1, detected=1, indicating that the CSI-2 bridge is detected and supported by the operating system. If you get detected=0, then the CSI-2 bridge is not being seen by the operating system.
Enable comment auto-refresher