N400

N400 Orange pi 4 metal case interface

Orange Pi 4 Case

N400 Orange Pi 4 case

Overview

This is Geekworm design metal case for the Orange Pi 4 / Orange Pi 4 Lts, not for Orange Pi 4B. You can refer to N400B if you want a metal case for Orange Pi 4B;

It reserves all the interfaces of the orange pi 4 motherboard, supports the cooling fan, supports the extraction of the GPIO cable, and also reserves 2 antenna holes for you to replace the antenna that comes with the motherboard.

Model: N400

Note: Only compatible with Orange Pi 4, NOT compatible with Orange Pi 4B!!!!You can refer to N400B if you want a metal case for Orange Pi 4B;

I can't understand why the naming of orange pi is so confusing. . . .

Features

Nice appearance
Good heat dissipation
Reserved GPIO cable hole
All ports and slots of the case can match with orange pi 4 / orange pi 4 lts board perfectly
Good wifi signal, reserves many round cooling holes on the side of the case, almost no weakeness for the WIFI signal;
2 antenna holes are reserved to facilitate the installation of external antennas
High quality metal material with surface galvanized process;
Case size:9.6x6.2x3.5cm/3.77x2.44x1.37inch
with VESA mounting hole, you can hang it on the wall or somewhere you want
About the cooling fan, the fan label marks 12V but it is also ok to use with your orange pi board.

Packing List

1 x Orange pi 4 metal case
1 x Cooling fan
1 x Installation screws pack

Document

Enable comment auto-refresher

Anonymous user #1

19 months ago

Score 0

Just at a glance it seems you mixed up the pictures for the orange pi 3 and 4. The connections on these orange pi 4 match with the 3 and vice versa. I might be wrong but check it out please.

Permalink | Reply

Walker