X-UPS1
Jump to navigation
Jump to search
Contents
Overview
The X-UPS1 is an universal stackable uninterruptible power supply (UPS) shield for most Single-Board Computers (SBC) that uses 12Vdc or 5Vdc. The UPS ensures that in event of power interruption, a battery or any other power source will intervene without any effect on your board.
Our convenient stackable design allows you to connect several UPS modules on your boards to provide long-lasting & higher output power.
SAFETY INSTRUCTIONS AND WARNINGS
- You must read these safety instructions and warnings before charging your batteries.
- Lithium Polymer and Li-ion batteries are volatile. Failure to read and follow the below instructions may result in fire, personal injury and damage to property if charged or used improperly.
- Never make wrong polarity connection when charging and discharging battery packs. Always double check polarity of battery's connector to make sure "+" to "+" and "-" to "-".
- Do not mix and use old batteries and new batteries, or batteries with different brand names.
- Lithium batteries has it's cycle life, please replace old battery with new one when it reaches it's service life or when it is two year old, whichever comes first.
- When charging Battery Pack, please put battery in a fire proof container. Please don't leave the X-UPS1 on the wood material or carpet and unattended.
- Must keep the X-UPS1 away from children.
- Please watch Main Video and Tutorial Video regarding 18650 batteries at: https://www.staysafebattery.com/en/
- Battery Recommend for X-UPS1 board, please refer to: File:NCR18650B.pdf
Features
For use with |
Most Single-Board Computers (SBC) that uses 12Vdc or 5Vdc,
|
Key Features |
Power Output
Battery Charging
Power Input
Power Control
Misc
|
Spec |
|
Note |
Notes for stackable application:
|
Packing List
- 1 x X-UPS1 Expansion Board
- 1 x VH3.96 to DC5525 Cable (50cm length, to 12V output)
- 1 x XH2.54 to DC5521 Cable (50cm length, to 5V output)
- 1 x 4Pin PH2.0 to dupont cable (30cm length, this is a signal & 5V Output Cable)
- 1 x GPIO Header
- 2 x Jumper link Pitch 2.54mm
- 4x Spacer F/F M2.5x10mm
- 4 x Spacer M/F M2.5x25+6mm
- 4 x Screw M2.5 x 5mm
User Manual
X-UPS1 V1.3 Jumper Cap & Button Switch Guidance:
Application
- Example.jpg
Caption2
PCB Dimension
X-UPS1 Dimensions source file (DXF): File:X-UPS1-PCB.dxf - You can view it with Autodesk Viewer online
Enable comment auto-refresher
Anonymous user #7
Permalink |
Lisa
Anonymous user #6
Permalink |
Lisa
Anonymous user #5
Permalink |
Anonymous user #4
Permalink |
Walker
Anonymous user #3
Permalink |
Walker
Walker
Anonymous user #3
Permalink |
Anonymous user #2
Permalink |
Walker
Anonymous user #1
Permalink |
Walker