X630-Hardware
Jump to navigation
Jump to search
10-pin functional connector
Pin No. | Pin Name | Function | Note |
---|---|---|---|
1 | 3V3 | 3.3V output | 3.3V |
2 | HDET | HDMI input detect (high level ) | 3.3V |
3 | IR | Infrared signal | 3.3V |
4 | INT | Interrupt Output signal – active high (Level) | 3.3V |
5 | RESET | System reset input, active low | 3.3V |
6 | A_SCK | I2S/TDM Bit Clock signal (BCK) | 3.3V |
7 | A_WFS | I2S Word Clock or TDM Frame Sync signal (LRCK) | 3.3V |
8 | A_OSCK | Audio Oversampling Clock (MCLK) | 3.3V |
9 | A_SD | I2S/TDM data signal (Data) | 3.3V |
10 | GND | Ground | 0V |
X630 Reset Setting
SELECTION | SWITCH SETTINGS | |
---|---|---|
Hardware reset | HW = 1 | SW = 0 |
Software reset | HW = 0 | SW = 1 |
Hardware reset: After starting RASPISTILL or RASPIVID once then you will need to reboot Raspberry Pi to restart it again
(Please use when operating system cannot control the X630 module via GPIO509)
Software reset: Starting RASPISTILL or RASPIVID multiple times and don't need to reboot Raspberry Pi