Main public logs

Combined display of all available logs of Geekworm Wiki. You can narrow down the view by selecting a log type, the username (case-sensitive), or the affected page (also case-sensitive).

• 18:19, 29 May 2023 92.60.179.76 talk performed unknown action "comments/add" on X708 (Hi I tried to connect battery low led to external PH2.0 connector but it seems like it does not light up when battery low blinks on the board and when i run continuity test on that connector (when board is off) there is a short between pins 2 and 3 to ground. I have X708 v2.0, is this my board's fault or schematic has changed for external power switch? It seems like it was reworked to adapt for 4 pin momentary switch with led light (so pins go like this power on/gnd/gnd/power led))