Related changes
← X1201
Jump to navigation
Jump to search
Enter a page name to see changes on pages linked to or from that page. (To see members of a category, enter Category:Name of category). Changes to pages on your Watchlist are in bold.
List of abbreviations:
- N
- This edit created a new page (also see list of new pages)
- m
- This is a minor edit
- b
- This edit was performed by a bot
- (±123)
- The page size changed by this number of bytes
18 August 2024
23:58 | Comments log 113.255.67.79 talk posted a new comment on X1001 (How to use with hailo) |
17 August 2024
07:18 | Comments log 76.176.206.26 talk posted a new comment on X1004 (I can confirm the X1004 worked with nvme WD_BLACK 2TB SN850X. Also worth noting, I was using a USB C extension cable. I had to remove it to get sufficient power or the RPI would turn off after a few seconds.) |
15 August 2024
|
19:13 | (Comments log)[Lisa (2×)] | |||
|
19:13 Lisa talk contribs posted a new comment on X1203 (Hi,LED lights do not support software settings.There is a learning process for the IC to read the power level, please try to fully charge and then discharge it a few times and it will remember the process.) | ||||
|
19:10 Lisa talk contribs posted a new comment on X1202 (Hi,There is a learning process for the IC to read the power level, please try to fully charge and then discharge it a few times and it will remember the process.) |
12 August 2024
|
07:24 | (Comments log)[121.225.189.42 (2×)] | |||
|
07:24 121.225.189.42 talk posted a new comment on X1202 (After that, I turned off the power input of the charger and continued to read the feedback value of the battery gauge. It is slowly increasing, even though I have disconnected the charger. It will reach around 80% battery level in about 30 minutes.) | ||||
|
07:22 121.225.189.42 talk posted a new comment on X1202 (Hello, I am using the x1202 model of UPS, and I have encountered a phenomenon. When the battery is low, I charge the UPS and shut down the Raspberry Pi. After the charging current drops to 0, I turn on the Raspberry Pi to check the battery level, but it shows only 1%. However, the battery voltage has already reached 4.2V. It seems that there is an error in the battery gauge.) |