X635-Software
Jump to navigation
Jump to search
X635 Software Guide base on Raspberry Pi OS bullseye
- To use the HDMI to CSI-2 bridge, you will need to enable Enable legacy camera support.
- Again open a terminal window and type the following command:
sudo wget https://datasheets.raspberrypi.org/cmio/dt-blob-cam1.bin -O /boot/dt-blob.bin #Download the required file /boot/dt-blob.bin
- Reboot for the dt-blob.bin file to be read
sudo reboot
- Open the Terminal and run the command to check if the HDMI to CSI-2 bridge is being seen by the operating system.
Note: You should get back supported=1, detected=1, indicating that the CSI-2 bridge is detected and supported by the operating system. If you get detected=0, then the CSI-2 bridge is not being seen by the operating system.
- Connect the HDMI in device to x635 carrier board.
connection sample diagram
IMPORTANT! The HDMI to CSI-2 bridge only accepts HDMI input: 1080p30, 1080p25, 720p30, 720p25
Enable comment auto-refresher