X729
Overview
Features
Smart and powerful Uninterruptible Power Supply (UPS)
UPS Output
- Provides continuous operations for up to 10~30hours (depending on battery type and qty used)
- Max 5.1V 6000mA Power Backup for even the most demanding RPi set ups
- Integrated TI INA219 12-bit current/voltage/power monitor
- Measure both output voltage and current draw over I2C with high precision
- Integrate Advanced Power MOSFET with Equivalent of 7mΩ RDS(ON) to reduce power loss
Battery Charging
- Supports 3000mA fast battery charging
- Battery over current protection and over voltage protection
- Protection of battery cell Reverse Connection
- Integrated Maxim's fuelgauge systems (Reading battery voltage and percentage over i2c)
- Onboard 4 green LEDs indicate battery charging and discharging levels of 25%, 50% , 75% and 100%
- 18650 two cells lithium Ion holder
Power Input
- Integrated highefficiency stepdown DCDC converter
- Wide 6V to 24V operating input range
- Up to 95% Efficiency
- Up to 10A output current to keep 3A fast charging and powering Raspberry Pi at the same time
- Allows powering from a car, a solder pannel and other power sources
- Most common power input jack: 5.5x2.1mm
Power Management
- Onboard push button to control power on, safe shutdown, reboot and force shutdown
- Supports full poweroff from software
- Onboard blue LED shows the status of power on, reboot and shutdown
- AC power loss or power adapter failure detection (LED, GPIO and buzzer alarm)
- Jumper setting to enable Auto power on when power applied or restored
- Automatic safe shutdown when battery low (voltage programmable)
- Onboard buzzer alarm for power loss and low battery
- Ultralow standby power consumption to maximize battery life
- Advanced system powerpath management avoids batteries frequent charging and discharging
RTC
- Integrated Hardware Real Time Clock (RTC) with Battery BackUp
- Keeps track of the time while the Raspberry Pi is switched off
- Uses the most common DS1307 RTC real time clock
- Uses the 18650 battery to maintain the date and time no additional battery required
FAN
- Dedicated PWM cooling fan for Raspberry Pi
- Air flow up to 6.01CFM and maximum speed of 5000 RPM
- Smooth PWM adjustment provides a quiet experience
- RealTime fan speed reading
- Programmable temperature and fan speed
Misc
- Powers the Raspberry Pi via the 40pin header no additional cabling required
- Reserved 40pin stackable Header for AddOn Boards
- 1x4 Pin header and Screw holes for OLED display
- Works with all current models of the Raspberry Pi using a 40 pin header
- XH2.54 connectors for extra battery x1, 5V output x2
- PH2.04P for external power switch
Specification
- Power input: 624Vdc ±5%, ≥3A
- UPS output : 5.1V ±5% Max 6A
- UPS charging current: 2.3~3.2A
- Terminal Battery Voltage : 4.24V
- Battery Recharge Threshold : 4.1V
Enable comment auto-refresher
Anonymous user #12
Permalink |
Lisa
Anonymous user #9
Permalink |
Anonymous user #10
Anonymous user #9
Permalink |
Anonymous user #11
Lisa
Anonymous user #8
Permalink |
Walker
Harry
Anonymous user #8
Permalink |
Walker
Anonymous user #7
Permalink |
Walker
Anonymous user #6
Permalink |
Walker
Anonymous user #5
Permalink |
Walker
Anonymous user #4
Permalink |
Lisa
Anonymous user #3
Permalink |
Lisa
Anonymous user #2
Permalink |
Lisa
Lisa
Anonymous user #1
Permalink |
Lisa