N400

N400 Orange pi 4 metal case interface

N400 Orange pi 4 metal case interface

Orange Pi 4 Case

N400 Orange Pi 4 case

Overview

This is Geekworm design metal case for the Orange Pi 4 / Orange Pi 4 Lts, not for Orange Pi 4B. You can refer to N400B if you want a metal case for Orange Pi 4B;

It reserves all the interfaces of the orange pi 4 motherboard, supports the cooling fan, supports the extraction of the GPIO cable, and also reserves 2 antenna holes for you to replace the antenna that comes with the motherboard.

Model: N400

Note: Only compatible with Orange Pi 4, NOT compatible with Orange Pi 4B!!!!You can refer to N400B if you want a metal case for Orange Pi 4B;

I can't understand why the naming of orange pi is so confusing. . . .

Features

• Nice appearance
• Good heat dissipation
• Reserved GPIO cable hole
• All ports and slots of the case can match with orange pi 4 / orange pi 4 lts board perfectly
• Good wifi signal, reserves many round cooling holes on the side of the case, almost no weakeness for the WIFI signal;
• 2 antenna holes are reserved to facilitate the installation of external antennas
• High quality metal material with surface galvanized process;
• Case size:9.6x6.2x3.5cm/3.77x2.44x1.37inch
• with VESA mounting hole, you can hang it on the wall or somewhere you want
• About the cooling fan, the fan label marks 12V but it is also ok to use with your orange pi board.

Packing List

• 1 x Orange pi 4 metal case
• 1 x Cooling fan
• 1 x Installation screws pack