Template:KVM-FAQ: Difference between revisions
No edit summary |
No edit summary |
||
| Line 31: | Line 31: | ||
* Run the command <code>systemctl status kvmd-tc358743</code> to check whether the video service is working properly. | * Run the command <code>systemctl status kvmd-tc358743</code> to check whether the video service is working properly. | ||
</div> | </div> | ||
</div> | </div> | ||
| Line 157: | Line 149: | ||
[[File:IMG-2173-1.jpg|600px]] | [[File:IMG-2173-1.jpg|600px]] | ||
</div> | |||
</div> | |||
<div class="toccolours mw-collapsible mw-collapsed"> | |||
<div style="font-weight:bold;line-height:1.0;"> | |||
<span class="tb_red">Q: Why is the X680 not working?</span> | |||
</div> | |||
<div class="mw-collapsible-content"> | |||
A: | |||
1. '''Firstly, must make sure the hardware expecially CM4 is connected correctly and securely. | |||
* Check if the X680's onboard SYS-PWR, CM-PWR, CM-ACT LEDs are lit. | |||
* If SYS-PWR LED is not lit, that means no power to X680; '''If the CM-PWR and CM-ACT LEDs are not lit, that means that the CM4 is not installed properly. Please recheck the CM4 installation, or check if the CM4 / X680 installation slot is damaged.(This is important! Many problems are caused by poor contact of CM4)''' | |||
* If the X680's SYS-PWR, CM-PWR, CM-ACT LEDs are lit, then check the wiring connection. | |||
Please refer to the following picture for the wiring connection and LED description. | |||
[[File:X680-IMG-5523-Connection-Diagram-New.jpg|900px]] | |||
[[File: X680-CM4-install1.jpg|800px]] | |||
2. '''Make sure to use the right pikvm OS. Only PiKVM V3 is supported'''. | |||
V3 Pre-Assembled version already includes OLED display configuration, while V3 HAT Kit version need to configuring OLED yourself. | |||
[[File:Pi4-V3-HAT.png|800px]] | |||
3. <span class="tb_red">Important: Remove the USB cable after programming is complete. </span> | |||
4. Please email us at <span class="tb_blue">support@geekworm.com</span> if you have further questions. | |||
</div> | </div> | ||
</div> | </div> | ||
| Line 173: | Line 195: | ||
These 3 USB ports are used for local switching between target PC1-PC4, e.g. a USB disk with the OS image can be used to install the os in PC1, if switching to PC2, then the os can be installed in PC2, and so on. | These 3 USB ports are used for local switching between target PC1-PC4, e.g. a USB disk with the OS image can be used to install the os in PC1, if switching to PC2, then the os can be installed in PC2, and so on. | ||
</div> | </div> | ||
</div> | |||
<div class="toccolours mw-collapsible mw-collapsed"> | |||
<div style="font-weight:bold;line-height:1.0;"> | |||
Q: Does the x680 support audio? | |||
</div> | |||
<div class="mw-collapsible-content"> | |||
A: Yes. Refer to [[Enable pikvm hdmi audio]]</div> | |||
</div> | </div> | ||