Difference between revisions of "X635-Software"
Jump to navigation
Jump to search
Line 2: | Line 2: | ||
<big>X635 Software Guide base on Raspberry Pi OS bullseye</big> | <big>X635 Software Guide base on Raspberry Pi OS bullseye</big> | ||
− | To use the HDMI to CSI-2 bridge, you will need to enable '''[[How to enable camera support in Raspberry Pi OS|Enable legacy camera support]]'''. | + | 1. To use the HDMI to CSI-2 bridge, you will need to enable '''[[How to enable camera support in Raspberry Pi OS|Enable legacy camera support]]'''. |
+ | 2. Reboot the device | ||
+ | sudo reboot | ||
+ | |||
+ | 3. Again open a terminal window and type the following command: | ||
+ | sudo wget https://datasheets.raspberrypi.org/cmio/dt-blob-cam1.bin -O /boot/dt-blob.bin | ||
+ | #Download the required file /boot/dt-blob.bin | ||
+ | |||
+ | 4. Reboot for the dt-blob.bin file to be read | ||
+ | sudo reboot | ||
+ | |||
+ | 5. Open the Terminal and run the command to check if the HDMI to CSI-2 bridge is being seen by the operating system. | ||
[[File:X635-software-15.png|700px]] | [[File:X635-software-15.png|700px]] |
Revision as of 19:33, 24 April 2023
X635 Software Guide base on Raspberry Pi OS bullseye
1. To use the HDMI to CSI-2 bridge, you will need to enable Enable legacy camera support.
2. Reboot the device
sudo reboot
3. Again open a terminal window and type the following command:
sudo wget https://datasheets.raspberrypi.org/cmio/dt-blob-cam1.bin -O /boot/dt-blob.bin #Download the required file /boot/dt-blob.bin
4. Reboot for the dt-blob.bin file to be read
sudo reboot
5. Open the Terminal and run the command to check if the HDMI to CSI-2 bridge is being seen by the operating system.
X635-software-18.png
Enable comment auto-refresher