5,169
edits
Changes
X880
,* Supports installation of X880-A1 A2 2.5 "/ 3.5" SATA SSD/HDD Shield
==About Raid setup==
【RAID setup and Jumper setting】
＊Warning : Please backup your data before setup and switch, otherwise you will lost your data.
#1.Install the HDDs
#2.Please connect the X880 to your PC and keep power on.
#3.Switch RAID mode
* 3.1 Set the switch button to your preferred RAID mode(PM/RAID 0/RAID 1/SPAN) as per the RAID illustration table.
* 3.2 Press the SET button for about 5 seconds, and release it till the blue LED indicators starts flashing.
* 3.3 After RAID mode changed, please confirm that the PC can recognize the disk(s) properly and shows the right capacity.
#4.Set CLEAR RAID mode (PM, factory default setup)
* 4.1 Press the SET button for about 5 seconds then and release it till blue LED indicators starts flashing.
* 4.2 After above processes, the setup for CLEAR RAID is done.
==Power Supply Requirement==
* Power supply: '''12Vdc''' +/-5% , ≥3A