3,080
edits
Changes
Jump to navigation
Jump to search
|-
| ''' Technical Specification''' ||
<span class="tb_red">'''Power supply:''' 35-57VDC powering over Ethernet</span> or <span class="tb_red">40-57Vdc via Auxiliary power jack</span>[Power supply is selectable between the two; simultaneous power is not supported.]
'''Ports & Connectors:'''
[[File:X1012-P579-V2-Installation.jpg|600px]]
===Configuration TutorialHow to make it work===You need to do some configuration based on the current OS before the SSD can work, which is a basic requirement for RPi 5.
# '''Enable PCIe''' to make nvme ssd work, please refer to [[NVMe SSD boot with the Raspberry Pi 5]]
# Tell Run the following command to tell the Pi that the X1012 POE is capable of 5A, so the USB current will get the full 1.6A::<pre>sudo rpi-eeprom-config -e</pre>
::Add <code>PSU_MAX_CURRENT=5000</code> at the end of the file that reads like this: