440
edits
Changes
Jump to navigation
Jump to search
1. '''1. X-UPS1 V1.3 Jumper Cap & Button Switch Guidance:'''
# You can use same one board to turn on/off all stackable boards. (be noted that which board you press the button to turn on, also must the same board to turn off.)
# Only one AL_ON jumper caps be shorted to enable Always Power On when stacked multiple x-ups1 shields.
# MUST When stacking more than 2 X-UPS1 boards, if you want to disable the 12V OUT, you have to short ALL 12 the 12V OFF jumper caps be . If one of them is not shorted to disable , the 12V output when stacked multiple x-ups1 shieldsOUT will occur.
|}
==User Manual==
[[File:X-ups1-IMG-5311-Jumper-Cap-1.jpg|750px|Jumper Cap & Button Switch Function]]
'''2. Guide based on the Raspberry Pi 5;'''
If you are using the X-UPS1 with the Raspberry Pi 5, you will need to do the following configuration on the Raspberry Pi 5:
[[File:X120x setting1.png]]
Then reboot your Raspberry Pi 5 to make the change take effect.
sudo reboot
==Application==
* Please watch Main Video and Tutorial Video regarding 18650 batteries at: https://www.staysafebattery.com/en/
* Battery Recommend for X-UPS1 board, please refer to: [[File:NCR18650B.pdf|X728 battery recommend]]
==FAQ==
<div class="toccolours mw-collapsible mw-collapsed">
<div style="font-weight:bold;line-height:1.0;">
Q: About X-UPS1 External PH2.0-4P Switch
</div>
<div class="mw-collapsible-content">
A: The X-UPS1 has a JST PH2.0-4P switch connector reserved to allow you to use an external reset switch to fulfill the function of the on-board switch in appropriate scenarios.
Care needs to be taken to use the correct wiring sequence for your momentary self-reset switch, please refer to the silkscreen description on the PCB board, you can refer to [[PSW19]] or purchase it from https://geekworm.com/products/power-control-switch-for-x820-or-x735
</div>
</div>
<!--Add review function! -->