5,208
edits
Changes
'''PCB Size:''' 87mm x 56mm
|}
==User Manual==
* Hardware Installation： [https://suptronics.com/Raspberrypi/Storage/x1012-v1.2_hardware.html X1012 Hardware]
* Configuration Tutorial：
# Enable PCIe to make nvme ssd work, please refer to [[NVMe SSD boot with the Raspberry Pi 5]]
# Tell the Pi that the X1012 POE is capable of 5A, so the USB current will get the full 1.6A
:: sudo rpi-eeprom-config -e
::Add <code>PSU_MAX_CURRENT=5000</code> at the end of the file that reads like this:
::[[File:X1012-setting.png|700px]]
::Press '''Ctrl-O''', then enter, to write the change to the file.
::Press '''Ctrl-X''' to exit nano (the editor).
::Reboot your Raspberry Pi 5 to make the change take effect.
* Introduction to Implementing Auxiliary Power on POE: [[File:AN3472-Implementing-Aux-Power-in-PoE.pdf]]
==Test & Reviews==
* 1 x X1012 V1.2 NVMe witj POE shield
* 2 x PCIe FFC (30mm length, Provides a backup)
* 8 10 x M2.5*5 scewsscrews* 4 x M2.5*18 19 F/F Spacer ==User Manual=====Hardware Installation===[https:* 1 x M2.5* 7 F//suptronicsF Spacer (And two M2.com/Raspberrypi5*5 screws to fix the 2230/Storage2242/x1012-v1.2_hardware.html X1012 Hardware]2260 SSDs) ===Software Installation===[https://suptronics.com/Raspberrypi/Storage/x1012-v1.2_software.html X1012 Software]* 1 x CM2x3 screw (sliver color, to fix 2280 SSD only)
==FAQ==