Related changes
← X728
Jump to navigation
Jump to search
Enter a page name to see changes on pages linked to or from that page. (To see members of a category, enter Category:Name of category). Changes to pages on your Watchlist are in bold.
List of abbreviations:
- N
- This edit created a new page (also see list of new pages)
- m
- This is a minor edit
- b
- This edit was performed by a bot
- (±123)
- The page size changed by this number of bytes
16 September 2024
| 19:59 | Comments log 86.141.76.93 talk posted a new comment on X728 (for the benefit of other users, be ware xSoft.sh has been updated on 13/09/2024 to fix this - GPIO pins were not being reset properly) | ||||
15 September 2024
|
|
20:36 | (Comments log)[185.50.233.235 (2×)] | |||
|
|
20:36 185.50.233.235 talk posted a new comment on X728-script (Only one more question: if the set is -> "CHG Ctrl" - Open : GPIO16 output stays high: Charging enabled, is it also a battery automatic charging, as if the jumper would be shorted? Or I have to set 0 after the batteries are fully recharged, otherwise it remains on constant charging?) | ||||
|
|
20:30 185.50.233.235 talk posted a new comment on X728-script (Hi! I experienced also some strange behavior. Shorting Chg En charges the batteries very fast to 100%, and then it goes down to 93% in couple of hours and then it will be recharged again and repeats. Very fast cycle, I think it kills the batteries very fast. If I don't short, the batteries go down from 100% to 95% in a night time, so it is also very fast. I assumed that if the board is powered, the batteries remain intact and keep capacity for months or so. What I found out is that the GPIO...) | ||||