5,208
edits
Changes
# Enable PCIe to make nvme ssd work, please refer to [[NVMe SSD boot with the Raspberry Pi 5]]
# Tell the Pi that the X1012 POE is capable of 5A, so the USB current will get the full 1.6A
:: sudo rpi-eeprom-config -e::Add PSU_MAX_CURRENT=5000 at the end of the file that reads like this:
::[[File:X1012-setting.png|700px]]
::Press Ctrl-O, then enter, to write the change to the file.
::Press Ctrl-X to exit nano (the editor).
::Reboot your Raspberry Pi 5 to make the change take effect.
* Introduction to Implementing Auxiliary Power on POE: [[File:AN3472-Implementing-Aux-Power-in-PoE.pdf]]