5,089
edits
Changes
Jump to navigation
Jump to search
no edit summary
</div>
<div class="mw-collapsible-content">
[[File:Supported-SSD-1.jpg|thumb|right|200px300px|click it to zoom out]]
A: Here are a few steps to help you troubleshoot some issues：
#'''Only''' Raspberry Pi OS ('''Bookworm''') supports PCIe, Raspberry Pi OS bullseye is NOT supported, refer to https://www.raspberrypi.com/software/operating-systems/
# Add '''''PCIE_PROBE=1''''' to the eeprom, (Run '''sudo rpi-eeprom-config --edit''' command, then add this line, then press CTRL+O to write change to file, press CTRL+X to exit, then reboot)
# Read [https://geekworm.com/community/forum/topic/120764/geekworm-x1001-for-raspberry-pi-5 this post] to get some help;
# Make sure the SSD type you use is correct, only support <span class="tb_red">M.2 NVME (Sata) Key-M SSD '''</span>NOT support''' M.2 NGFF Key-B SSD. Refer to the right diagram (click it to zoom out):
# Make sure the FPC cable is '''firmly and fully inserted''' into the PI 5, this is '''very important'''. For [[X1003]] shield, make sure the FPC cable '''direction''' is correct also.
# <span class="tb_red_bold">For [[X1003]] shield, make sure the FPC cable '''direction''' is correct also. If an error still occurs, replace the FFC cable to test or purchase other PFC from here<ref>Amazon US: https://www.amazon.com/dp/B0CXCTPQ2N