1,823
edits
Changes
Jump to navigation
Jump to search
* Upgraded to USB3.1 Gen1 port; (SupportS USB 3.0) w/ high quality USB 3.0 Cable ( Lenght- 80cm/2.62inch; Diameter- 5.96mm/0.19inch)
* Use upgrade Main control chip to solve the problem that the 'reboot' command is not supported in the V1.3 function.
* The HDMI adapter has been removed, which reduces the difficulty of installation; it also facilitates the design and installation of the accessory enclosure;
X820
,==Features==
* Operating System: All Raspberry Pi operating systems
* Supports up to 4TB 2.5-inch SATA hard disk drives (HDD) / solid-state drive (SSD)
* USB 3.1 Gen1 to SATA 6Gb/s Bridge Controller
* On-board powers button switch for power control
* Add upgraded external 5V 2A power output USB port for external device such as cellphone and other device, of course. User can power the raspberry pi via this USB port when GPIO pins are occupied by other expansion board.
* User can directly use the X820 V3.0 board as a mobile hard disk even if you don't power it (tested; with our USB3.0 cable or use a good quality and relatively short USB3.0 cable); PS: In the V1.3 version, you need to power the X820 at the same time as when you use the X820 V1.3 board as a mobile Hard disk;
* Two kinds of power supply modes are supported; One of mode is that power the raspberry pi via 2 pin cable by connecting to GPIO2 (5V) and GPIO3(GND) pins, the other one of mode is power the raspberry pi via USB port; PS: DON'T USE THE TWO KIND MODES AT THE SAME TIME;