CommentStreams:82f3dc7eacd60075901ed9eb8cfc47b6

I looked at pages 5 and 6 of the manual and sent the commands exactly as they are described and got no response from the unit. What encoding is used, ASCII? I have the following settings:

Baud rate: 115200 Data bits: 8 Parity: None Stop bit: 1 No carriage return/line break after commands UART TX → Board RX; UART RX → Board TX

Can you send me the command set in HEX format? Not the text. For example, if I assume ASCII is being used, if the command is "test 100 14" you would send me "74 65 73 74 20 31 30 30 20 31 34". (the last two bytes could be blank because that would be the parameter) And that is what's sent over RS232.