EDP to HDMI Adapter

EDP to HDMI Adapter V1.3-Front

EDP to HDMI Adapter V1.3-Back

EDP to HDMI Adapter V1.3 Interface

EDP to HDMI adapter V1.2-Front

EDP to HDMI adapter V1.2-Back

EDP to HDMI Adapter V1.2 Interface

Overview

S.EDP-HDMI-4K2K.V1.2 is a signal adapter board, which is mainly used to convert EDP signal into HDMI signal, the resolution of this adapter supports up to 4K 30HZ resolution. The adapter can be used in set-top boxes, advertising machines, conference systems and other fields. EDP input needs to comply with EDP1.1, EDP1.2 standards;

Update History: Update to V1.3 version from V1.2 version in December 2022, and add the EDP SET switch to switch 2LANE and 4LANE.

Important Note

1.For general computers or industrial motherboards:
These adaptive output motherboards typically support only 1080P(2 lane) or 4K(4 lane) resolutions. Resolutions below 1080p or equal to 2K CAN NOT be supported. To support 1080p resolution please make sure that the motherboard meets the 2-lane EDP requirement. Please DO NOT use it to connect your PC if the resolution of your screen is not 1080P or 4K.

2.For Android/Linux solutions from Qualcomm, Rockchip, Allwinner, or certain LCD driver boards:
These solutions usually use fixed output EDP signals. Make sure these signals can output standard resolution and refresh rates and adhere to HDMI timing specifications, then EDP to HDMI adapter will support 1/2/4 lane EDP signals.

Features

Features ( EPD/DP RX )：

Compliant with VESA EDP/DP1.2
Support 1.62/2.7/5.4Gbps
Support 1/2/4 lanes （Default with 2 lanes program）
Support SSC
1Mbps AUX channel
Compliant with HDCP1.3

Features ( HDMI TX)：

Compliant with HDMI2.0, HDMI1.4 and DVI1.0
Compliant with HDCP2.2 and HDCP1.4
IData rate up to 6Gbps
Support UHD 4k@60Hz(RGB and YCbCr 4:4:4)
Support TMDS scrambling for EMI/RFI reduction
Support SCDC(Status and Control Data Channel)

Configuration & General Precautions

Relative humidity: ≤ 80%.
Storage temperature: -20~60°C.
Operation temperature: -20~60°C.
Protect the board from static electricity in case of damage to the IC.
Keep the board away from conductor when it is working.
Don't wire in the board to power supply before panel is correctly connected.
Operating:Less than 2000m

Power Supply

The EDP to HDMI Adapter obtains power through 30 Pin 2 lane port or 40 Pin 4 lane prot.
Default power supply voltage: 3.3V. After upgrading hardware components the voltage can be increased to 5-12V. Contact us if you need custom boards with an operating voltage of 5-12V.