5,105
edits
Changes
Jump to navigation
Jump to search
no edit summary
{{GD Template Impl}}
<big>Although this installation tutorial is still available, but we strongly recommend that you use [[X729-script]] new tutorial, and we no longer maintain this page.</big>
==Setup script==
The following test is base on * [https://downloads.raspberrypi.org/raspios_arm64/images/raspios_arm64-2023-05-03/2023-05-03-raspios-bullseye-arm64.img.xz 2023-05-03-raspios-bullseye-arm64.img.xz]
* [https://www.raspberrypi.com/software/operating-systems/ 2022-09-22-raspios-bullseye-armhf.img.xz]
* [https://www.raspberrypi.com/software/operating-systems/ 2022-09-22-raspios-buster-armhf.img.xz]
70: -- -- -- -- -- -- -- --
</PRE>
Explaination:
<PRE>
#36 - the address of the battery fuel gauging chip
#3c - address of oled display，This value only exists when the oled is inserted，check if the OLED displayis inserted in the correct direction if you don't found the above i2c port
#40 - TI INA219 12-bit current/voltage/power monitor
#68 - the address of the RTC chip
#Reboot the Raspberry Pi or long press on-board button switch to turn off
sudo rebootnow
3.3 Powering off the Raspberry Pi from software
x729off
6.3 Run the command and comment out these five lines:
sudo nano /lib/udev/hwclock-set
[[File:X729-7.png|none]]