X630-A8

From Geekworm Wiki
Revision as of 18:04, 19 November 2022 by Abby (talk | contribs) (→‎Overview)
Jump to navigation Jump to search

X630-A8-Front
X630-A8-Rear
X630-A8 Standard height PCIe Add-in Card I/O Bracket
X630-A8
X630-A8
PiKVM-A8: X630+X630-A8 for Pi 4

Overview

X630-A8 is an accessory for PiKVM-A8 (Raspberry Pi 4 based KVM over IP, PCIe version),the complete kit or other PiKVM version, please refer to PiKVM

PiKVM (https://pikvm.org/) is a very powerful and Open Source Software which allows for a remote connection via your Raspberry Pi to turn on/off or restart your computer, configure the UEFI/BIOS, and even reinstall the OS using the Virtual CD-ROM or Flash Drive. You can use your remote keyboard and mouse or PiKVM can simulate a keyboard, mouse, and a monitor, which are then presented in a web browser as if you were working on a remote system directly. It’s true hardware-level access with no dependency on any remote ports, protocols or services!

PiKVM-A8 PCIe Version allows user to realize a PiKVM / KVM project with Raspberry Pi 4.

NO extral connection wire require, easy to assemble and use.

Features

  • Designed especially for PiKVM (Raspberry Pi 4-based KVM over IP)
  • Installs justs like any PCI card into a tower / desktop PC
  • Fully compatiblie with PiKVM OS
  • Reliable remote network access to servers and computers
  • HDMI Full HD capture based on the TC358743 chip (from X630)
  • OTG Keyboard & mouse; Mass Storage Drive emulation
  • Hardware Real Time Clock (RTC) with CR1220 coin battery socket
  • Equipped with cooling fan that allows the heat from your Raspberry Pi to dissipate
  • Equipped with photocoupler to protect RPi GPIO pins from computer and ESD spikes
  • PoE Supported – Power over Ethernet for simplified installation
  • Also supports for powering via USB-C
  • Reserves the PH2.04P connector for I2C OLED display

Packing List

  • 1 x X630-A8 V1.7 Expansion Board
  • 1 x FPC cable (Length: 5cm)
  • 1 x ATX Control Cable (Length: 52cm)
  • 1 x Motherboard Internal USB 2.0 9-pin Female Header to TYPE-C USB OTG Cable (Length: 50cm)
  • 1 x USB3.0 IDC to TYPE-C (Length: 45cm)
  • 1 x Standard height PCIe Add-in Card I/O Bracket
  • 4 x M2.5x12mm F/F Spacers
  • 8 x M2.5x6mm Screws
  • 1x X630-A8-CAB V1.1 Camera Adapter board
  • 2 x PM3x6mm Screws
Add your comment
Geekworm Wiki welcomes all comments. If you do not want to be anonymous, register or log in. It is free.