2,869
edits
Changes
no edit summary
{{GD Template Impl}}
<big>Although this tutorial is still available, but we strongly recommend that you use [[XScript]] new tutorial, and we no longer maintain this page</big>
'''Note:''' Not tested with '''Home Assistant''', for some reason, we are not able to upgrade and use the Home Assistant to test, please pay attention to check if there is any update in the future.(If you have successfully tested Home Assistant, welcome to share your experience via email at: support@geekworm.com)
<hr/>
[Update]
Support [https://getumbrel.com/ Umbrel] now.
The script is '''not tested''' VMware ESXI ARM operating system. To make the 3pin PWM cooling fan running, please remove/pull out the yellow cable if you use X-C1 V1.3 version.Remove the jumper cap on "Fan FS" PIN of X-C1 V2.0 versionto let the fan running at full speed.
NOTE:
* Raspbian 2021-05-07-raspios-buster-armhf, 2021-10-30-raspios-bullseye-armhf.img, 2021-10-30-raspios-bullseye-armhf-lite.img
* RetroPie 4.7.1
* Twister OS v2.0.2 / Twister OS 2.1.2
'''install'''
sudo apt-get upgrade
sudo apt-get install -y unzip make gcc python git wiringpi python3-pigpio python-setuptoolspython3-rpi.gpio
sudo apt-get install -y python3-distutils
Login to mynode teminal via Putty or Xsheel tool, the default user name is `admin`, default password is `bolt`, then run the following command:
Login to mynode Umbrel teminal via Putty or Xsheel tool, the default user name is `umbrel`, default password is `moneyprintergobrrr`, then run the following command:
'''FAQ'''