5,026
edits
Changes
Jump to navigation
Jump to search
Support [https://getumbrel.com/ Umbrel] now.
The script is '''not tested''' VMware ESXI ARM operating system. To make the 3pin PWM cooling fan running, please remove/pull out the yellow cable if you use X-C1 V1.3 version.Remove the jumper cap on "Fan FS" PIN of X-C1 V2.0 versionto let the fan running at full speed.
NOTE:
* Raspbian 2021-05-07-raspios-buster-armhf, 2021-10-30-raspios-bullseye-armhf.img, 2021-10-30-raspios-bullseye-armhf-lite.img
* RetroPie 4.7.1
* Twister OS v2.0.2 / Twister OS 2.1.2
'''install'''
cd ~
sudo apt-get update
sudo apt-get -y upgrade sudo apt-get -y install i2c-tools python3-smbus python3-rpi.gpio sudo apt-get install -y git pigpio sudo apt-get install -y pigpio python3-pigpio python3-smbus
git clone https://github.com/geekworm-com/x-c1.git
cd x-c1
sudo apt-get upgrade
sudo apt-get install -y unzip make gcc python git wiringpi python3-pigpio python-setuptoolspython3-rpi.gpio
sudo apt-get install -y python3-distutils
About myNode, please refer to http://www.mynodebtc.com/
About Umbrel, please refetrto refer to https://getumbrel.com/
'''Install'''
[[File:Volumio-rc-local.jpg|800px]]
Q2:How to get the current fan speed value? As I remember old x735 software where with such read_fan_speed.py script example, but not found such in X-C1.
A: The X-C1's PWM fan is a 3Pin FAN, and does not support reading speed. The Fan of X735 is a 4Pin PWM fan.
<hr/>