Changes

# Make sure that your OS configuration (<code>/boot/firmware/config.txt</code>) is completely correct: refer to the tutorial:[[NVMe SSD boot with the Raspberry Pi 5]] (will Continuously updating)

# <span class="tb_red">Update the bootloader firmware to the last verson, refer to [[How to update eeprom firmware]], this is very important!!!</span>And finally be sure to run the command '''vcgencmd bootloader_version''' to check if your upgrade was successful!

# Read [https://geekworm.com/community/forum/topic/120764/geekworm-x1001-for-raspberry-pi-5 this post] to get some help;

# Make sure the SSD type you use is correct, only support <span class="tb_red">M.2 NVME (Sata) Key-M SSD '''</span>NOT support''' M.2 NGFF Key-B SSD. Refer to the following diagram (click it to zoom out): [[File:Supported-SSD-1.jpg|100px]]

# If you're flashing a fresh Pi OS into NVME SSD , DON'T forget to '''ENABLE PCIe''' to NVME SSD.

# Run the '''lspci''' and'''lsblk''' command to check the NVMe SSD is recognized.

<!--# If your SSD is old and has a '''DOS partition''', delete the DOS partition and repartition the SSD (feedback from buyer)-->

# Consider switching to other brands of NVME SSDs.

# Contact us at email: support@geekworm.com

<references />

</div>