5,154
edits
Changes
no edit summary
#Read [https://geekworm.com/community/forum/topic/120764/geekworm-x1001-for-raspberry-pi-5 this post] to get some help;
#Make sure the SSD type you use is correct, only support <span class="tb_red">M.2 NVME (Sata) Key-M SSD '''</span>NOT support''' M.2 NGFF Key-B SSD. Refer to the following diagram (click it to zoom out): [[File:Supported-SSD-1.jpg|100px]]
#Make sure the FPC cable is '''firmly connected to and fully inserted''' into the PI 5, this is '''very important'''.For [[X1003 ]] shield, make sure the FPC cable '''direction ''' is correct also.
#Although you can also boot from a SD card, Pi OS is required for the NVMe SSD to boot, DON'T forget Flash OS into NVMe SSD.
#If you're flashing a fresh Pi OS into NVME SSD , DON'T forget to '''ENABLE PCIe''' to NVME SSD.
#Add '''''PCIE_PROBE=1''''' to the eeprom, (Run '''sudo rpi-eeprom-config --edit''' command, then add this line, then press CTRL+O to write change to file, press CTRL+X to exit, then reboot)
#<span class="tb_red">Update the bootloader firmware to the last verson, refer to [[How to update eeprom firmware]], this is very important!!!</span>And finally be sure to run the command ''vcgencmd bootloader_version'' to check if your upgrade was successful!
#<span class="tb_red_bold">For [[X1003]] shield, if an error occurs, replace the FFC cable to testor purchase from here<ref>Amazon US: https://www.amazon.com/dp/B0CXCTPQ2N</ref><ref>Amazon DE: https://www.amazon.de/dp/B0CX4T993J</ref><ref>Amazon UK: https://www.amazon.co.uk/dp/B0CX4T993J</ref>.<span>
#If your SSD is old and has a '''DOS partition''', delete the DOS partition and repartition the SSD (feedback from buyer)
#Contact us at email: support@geekworm.com
<references />
</div>
</div>