Related changes
Enter a page name to see changes on pages linked to or from that page. (To see members of a category, enter Category:Name of category). Changes to pages on your Watchlist are in bold.
List of abbreviations:
- N
- This edit created a new page (also see list of new pages)
- m
- This is a minor edit
- b
- This edit was performed by a bot
- (±123)
- The page size changed by this number of bytes
17 May 2024
|
|
05:59 | (Comments log)[216.24.212.246; 216.24.212.210] | |||
|
|
05:59 216.24.212.210 talk posted a new comment on X1201 (would NOT take a charge) | ||||
|
|
05:58 216.24.212.246 talk posted a new comment on X1201 (Yes, the batteries were hardly used but one was bad; it would take a charge. Thanks) | ||||
11 May 2024
| 17:13 | Comments log Lisa talk contribs posted a new comment on X1202 (Hi,Please remove X1202 from Pi5, wipe the pogo pin with alcohol,then reinstall it. please adjust the position of the pigo pin appropriately so that it contacts the Pi5 well.) | ||||
10 May 2024
| 14:37 | Comments log 172.114.135.75 talk posted a new comment on X1202 (I noticed that the x1202 always said "AC Power OK" even with power plug disconnected. As the pld.py code ran I could press down on the Pi board and the x1202 would say "AC Power Loss". When I let up it would go back to "AC Power OK". Seems like a pogo is not making good contact. Any suggestions?) | ||||
9 May 2024
| 15:18 | Comments log Lisa talk contribs posted a new comment on X1201 (Hi,No need to setup a jumper and it automatically switches to being powered by the battery when power is removed. but please to make sure that your battery is not a low battery.) | ||||
7 May 2024
|
|
11:15 | (Comments log)[Lisa (2×); 23.114.212.80 (2×)] | |||
|
|
11:15 Lisa talk contribs posted a new comment on X1202 (pogo pins is power to Pi 5) | ||||
|
|
11:09 Lisa talk contribs posted a new comment on X1202 (Hi,①momentary switch port: XH2.54-2P; ②the functions of external switche and onboard switche are the same.) | ||||
|
|
09:07 23.114.212.80 talk posted a new comment on X1202 (One of the pogos looks like it contacts the area for the Real-time battery. Does this also supply power for that port?) | ||||
|
|
09:06 23.114.212.80 talk posted a new comment on X1202 (What are the specs on the momentary switch port? Does this work like one on the board?) | ||||
6 May 2024
| 04:17 | Comments log 216.24.212.37 talk posted a new comment on X1201 (X1201 V1.1 current behavior: On applying power starts charging and starts Pi5 via attached USB-C. When fully charged stops charging, quits using UBS-C power and uses power from the battery. When battery are depleted, shuts off everything. Also when you remove USB-C power, it does not transition to battery is shuts off everything. There is no software installed in crons or anything. This is not a seamless UPS. Is there a jumper of GPIO setting that I don't have set?) | ||||