<references />
==FAQ==
<div class="toccolours mw{{X100x-collapsible mw-collapsed"><div style="font-weight:bold;line-height:1.0; color:red;">Q1: Can't boot/recognize from NVMe SSD?</div><div class="mw-collapsible-content">A: Here are a few steps to help you troubleshoot some issues：# Firstly, you can read [https://geekworm.com/community/forum/topic/120764/geekworm-x1001-for-raspberry-pi-5 this post] to get some help;# Make sure the SSD type you use is correct, only support <span class="tb_red">M.2 NVME (Sata) Key-M SSD '''</span>NOT support''' M.2 NGFF Key-B SSD. Refer to the following diagram (click it to zoom out): [[File:Supported-SSD-1.jpg|100px]]# Check if the FFC is fully inserted. Is the HAT tightly connected? We recommend you to send us the FFC connection schematic as well.# '''Only''' Raspberry Pi OS ('''Bookworm''') supports PCIe, Raspberry Pi OS bullseye is NOT supported, refer to https://www.raspberrypi.com/software/operating-systems/# Although you can also boot from a SD card, Pi OS is required for the NVMe SSD to boot, DON'T forget Flash OS onto NVMe SSD.# If you're flashing a fresh Pi OS into NVME SSD , DON'T forget to '''ENABLE PCIe''' to NVME SSD.# Run the '''lspci''' and'''lsblk''' command to check the NVMe SSD is recognized.# Add '''''PCIE_PROBE=1''''' to the eeprom, (Run '''sudo rpi-eeprom-config --edit''' command, then add this line, then press CTRL+O to write change to file, press CTRL+X to exit, then reboot)# <span class="tb_red">Update the bootloader firmware to the last verson, refer to [[How to update eeprom firmware]], this is very important!!!</span>And finally be sure to run the command ''vcgencmd bootloader_version'' to check if your upgrade was successful!# For [[X1003]], if an error occurs, replace the FFC cable to test.# If your SSD is old and has a '''DOS partition''', delete the DOS partition and repartition the SSD (feedback from buyer)# Contact us at email: support@geekworm.com</div></div> <div class="toccolours mw-collapsible mw-collapsed"><div style="font-weight:bold;line-height:1.0;">Q2: Don't recognize / boot from NVME SSD?</div><div class="mw-collapsible-content">A: If you have '''enabled pcie''' and find that you still cannot boot from NVME SSD, please perform the following actions 1. Follow the picture below to check the version of [[X1001]] or [[X1000]] [[File:X1001-V1.1-IMG-6871-old-new.jpg|600px]] 2. If it is an '''Old Version''', refer to [[How to update eeprom firmware]] to update the firmware with '''pieeprom-2023-10-30.bin file'''. 3. If it is an '''New Version''', refer to [[How to update eeprom firmware]] to update the firmware to '''lasted version'''. 4. '''If you still have not solved the problem, please refer to the next FAQ:Q1'''</div></div>}}
Return to [[X1000]] / [[X1001]] / [[X1002]] / [[X1003]]