1,836
edits
Changes
Jump to navigation
Jump to search
M901
,{{GD Template Impl}}
==Overview==
The M901 shield is an NVME M2 SSD PIP (PCIe Peripheral Board) for the Raspberry Pi 5 that uses the new PCIE interface of the Raspberry Pi 5 to utilise the NVME M2 SSDs for fast data transfers and ultra-fast booting.
This shield follows the new "PIP" design guideline from Raspberry Pi fundation ensuring that it will be easy to use and be supported long term by updates to Raspberry Pi OS - though it is very early days and things are improving rapidly there!
{{PCIe to NVME Sets}}
==Important Note==
{{NVMe SSD Incompatibility List}}
==Features==
* Minimalist design, easy to install
* Compatible with other HAT shield;
* Supports installation of official active coolers;
* SSD ACT LED Indicators-On: Power OK/Standby, Flashing: Reading/Writing
* Supports 2230/2242/2260/2280 NVME M2 SSD
* Can power the M901 shield directly from the FFC PCIe ribbon (providing maximum 5W of continuous power)
PS:
* Maximum current for pcie connector is 1A, and voltage is 5V
* If you find that the SSD is not working properly, it is possible that the power supply of SSD is not enough, then you need to check the current requirement of your SSD to decide whether power the SSD separately.
* The X1001 hardware has no limit on NVME SSD capacity, which is dependent on the Raspberry Pi OS.
==Packing List==
* 1 x M901 PCIe to M2 NVMe PIP PCIe Peripheral Board
* 1 x PCIe FFC Cable (8.5mm Length)
* 6 x M2.5*5 Screws
* 3 x M2.5*17 Female/Female Spacers
* 1 x M2.5 Copper Nut to fix SSD 2230 / 2242 / 2260 Length
* 1 x M2.5X5 Screw to fix SSD 2230 / 2242 / 2260 Length
==User Manual==