1,823
edits
Changes
Jump to navigation
Jump to search
3. R28 is used to switch the JEIDA signal, it is VESA signal when without the you could weld a 0ohm-0603-±5%-1/10W resistanceon R18 position.
A:
1. Please confirm which version your board is the new version according to the picture;.
2. If yes, you could weld a 0ohm-0603-±5%-1/10W resistance on R18 position.it is the version as picture shows;
R28 is used to switch the JEIDA signal, it is VESA signal when without the resistance. [[File:LVDS to HDMI Board (New Version).jpg|600px400px]] 3. If your board is the newest version then you could switch to Single 8 mode by shorting GND and S1.
<comments/>