Difference between revisions of "H500"
Jump to navigation
Jump to search
| Line 29: | Line 29: | ||
* Maximum fan speed: 8000 RPM +/- 15% | * Maximum fan speed: 8000 RPM +/- 15% | ||
* Product material: Anodised aluminium | * Product material: Anodised aluminium | ||
| + | * Pinout: | ||
| + | The fan connector is a 1mm pitch JST SH socket and has four pins: | ||
| + | |||
| + | {| class="wikitable" | ||
| + | ! Pin !! Function | ||
| + | |- | ||
| + | | 1 || +5V | ||
| + | |- | ||
| + | | 2 || PWM | ||
| + | |- | ||
| + | | 3 || GND | ||
| + | |- | ||
| + | | 4 || Tach | ||
| + | |} | ||
==Documents== | ==Documents== | ||
Revision as of 16:58, 24 November 2023
Contents
Overview
This is the Raspberry Pi Official Active Cooler for Raspberry Pi 5.
The Raspberry Pi Active Cooler for Raspberry Pi 5 is a dedicated clip-on cooling solution for Raspberry Pi 5. It combines an aluminium heatsink with a temperature-controlled blower fan to keep your Raspberry Pi 5 at a comfortable operating temperature, even under heavy loads.
WARNINGS • This product should only be used with Raspberry Pi 5. • This product should only be operated in a well ventilated environment, and if used with a case, the case should not be covered. • Make sure the metal heatsink does not touch any electronic components on Raspberry Pi 5 or any accessories, to avoid the risk of unwanted electrical contact and shorting. • Ensure the thermal pads are present and undamaged before use. If the pads are missing or damaged, you will need to replace them before using the Active Cooler. • Take care when using the Active Cooler, as the metal parts of the product may become hot during operation. • Avoid removing the Active Cooler once it is fitted to Raspberry Pi 5, as this product is not designed for repeated removal and replacement.
Features
- Single-piece anodised aluminium heatsink
- Heatsink-mounted, temperature-controlled blower fan attached by three screws
- Spring-loaded push pins for mounting onto Raspberry Pi 5
- Pre-applied thermal pads for heat transfer
Specifications
- Input voltage: 5V DC supplied via four-pin fan header on Raspberry Pi 5
- Fan speed control: Pulse width modulation control with tachometer
- Maximum airflow: 1.09 CFM
- Maximum fan speed: 8000 RPM +/- 15%
- Product material: Anodised aluminium
- Pinout:
The fan connector is a 1mm pitch JST SH socket and has four pins:
| Pin | Function |
|---|---|
| 1 | +5V |
| 2 | PWM |
| 3 | GND |
| 4 | Tach |
Enable comment auto-refresher