X630-Hardware-Reset
First, we recommend that you read Raspberry Pi camera applications document
For Hardware Reset - Starting RASPISTILL or RASPIVID once then reboot your Raspberry Pi.
Use GStreamer Tools
You need an accessory board (X630#X630-A2) for audio capturing.
Please refer to CSI-2-Software if you are use the Raspberry Pi Bullseye OS
Use RASPISTILL RASPIVID
Only for OS before Rasberry Pi Bullseye OS such as Raspberry Pi Buster OS
1. Update & upgrade the raspberry pi system (It will take a long time depend on the different country)
sudo apt-get update sudo apt-get upgrade
2. Enable camera module (the camera is enabled by default in Raspberry pi Bullseys OS)
sudo raspi-config
Navigate to 'Interfacing Options' and hit Enter. Now select the 'Camera' option, and hit the Enter key to enable it. Select “Finish” and select to reboot your Raspberry Pi.
3. Edit /boot/config.txt to add the line (that will need sudo, and use 'sudo nano /boot/config.txt')
dtoverlay=tc358743
to the end of the file.
4. Reboot. If all is well you should get a /dev/video0 device.
pi@raspberrypi:~ $ ls /dev/video0 /dev/video0
4. To take a photo with the X630 Module
raspistill -o image.jpg
Here, "image" is the name of your image that will be saved to your Raspberry Pi
5. If you need to take second image, then you will need to reboot the Raspberry Pi and execute the "raspistill" again
sudo reboot
5. To record a video with the X630 module
raspivid -o video.h264 -t 10000
Here, "video" is the name of your video and "10000" is the number of milliseconds.
7. If you need to record second video, then you will need to reboot the Raspberry Pi and execute the "raspivid" again
sudo reboot
Audio&Video capturing using GStreamer
Refer to CSI Audio Video capturing using GStreamer
Enable comment auto-refresher