NASPi CM4-M2
Overview
NASPi CM4-M2 is a member of NASPi family. Click GEEKWORM NAS Family to know more.
NASPi CM4-M2 is a NUC-style storage kit based on Raspberry Pi CM4 all series. It has a M2 KEY-M (NVME) SSD interface and a M2 KEY-B (NGFF) SSD interface. Its OLED screen can display some informations like CPU temperature, IP address . Also provides 3 USB 2.0 ports and 2 full-size HDMI ports, supports safe shutdown (requires installation script).
Important note:
- Don't need to use additional SD card and power supply if you are using CM4 with emmc. When burning the system, please short the OTG on the X515 board; at the same time, use the USB-A to USB-C OTG cable (prepare it yourself) to connect to the computer.
Features
- Model: NASPi CM4-M2
- NUC style set-top box, compact design
- Compatible with M2 NVME SSD or M2 SATA SSD(Only support 2280 length SSD installation)
- Comes with an aluminum alloy heatsink C235 for CM4 passive cooling
- Comes with a 0.96 inch OLED display
- Support software safe shutdown & auto power on & RTC function
- On-board blue light button switch to control power ON/OFF
- Press button switch to turn on, hold for 1~2 seconds to reboot, hold for 3 seconds to safe shutdown, hold for more than 8 seconds to force shutdown
How to Power
Power supply: 5Vdc +/-5% , ≥4A
Recommend to use 20W 5V 4A Type-C power adapter PSU20.
How to Cool
- Comes with a 12mm thickness aluminum alloy heatsink C235 cooler for passive cooling of Raspberry Pi CM4, which can satisfy large file copy and video playback application. And it is recommended to replace the thermal pad with CPU silicone grease for better heat dissipation.
Packing List
- 1 x NASPi CM4-M2 aluminum alloy case
- 1 x X515 storage expansion board
- 1 x C235 aluminum alloy heatsink
- 1 x 0.96 inch OLED display
- 1 x Scews pack accessories
User Manual
- How to installing the Operating System (CM4 without eMMC)? Refer to Official installation tutorial
- How to flash OS onto the eMMC of CM4? (CM4 with eMMC)?
1. Short OTG Pin, refer to the picture below.
2. Connect Type-C OTG with a Type-A to Type-C cable to your computer
3. Power the device via PWR Type-C with your 5V Power adaper
4. Then rerfer to this tutorial to flash raspberry pi OS
5. Remove the jumper of OTG after flashing is complete, then restart your device;
- Power management & safe shutdown script Installation: XScript
Enable comment auto-refresher
Anonymous user #6
Permalink |
Anonymous user #6
Anonymous user #6
Walker
Anonymous user #5
Permalink |
Walker
Anonymous user #4
Permalink |
Walker
Anonymous user #3
Permalink |
Walker
Anonymous user #2
Permalink |
Harry
Anonymous user #1
Permalink |
Anonymous user #1
Abby