Changes

The ''' X15-POE1 ''' is a dedicated Power over Ethernet (PoE) addHead-on board At-Board (HAT) specifically designed for the '''Raspberry Pi Compute Module 5 (CM5) when used ''', requiring use with either the '''X1500 ''' or ''' X1501 ''' IO Boards boards. Compliant with the IEEE 802.3af/at (PoE standards+) standard, this HAT board can receive draw up to 25W 25.5W of power from a compatible PoE network switch. It delivers both reliable operating via a single Cat5e/Cat6 Ethernet cable, simultaneously providing stable operational power and network connectivity to for the CM5 through a single Cat5e/Cat6 cable.

Featuring an advanced dual-output design, the board supplies 5V power to the CM5 while also providing a separate an independent 12V output to support . This output can drive peripherals such as fans, displays, or motors. This eliminates the need for an additional external power supply, simplifying system integration and reducing clutter.

* ''' Standard Compliance''': IEEE 802.3af & 802.3at (PoE+)

* '''Input Voltage Range''': 37–57V DC

* '''Device Classification''': Class 4

* '''Dual Output Power Rails''':

# <span class="tb_blue">5V DC Output</ span>: Maximum current 5A (25W max) delivered provided via the 40-pin GPIO headerconnector)

# <span class="tb_blue">12V DC Output</ span>: Maximum current 2.1A (25W max) delivered provided via a dedicated 2-pin XH2.54 connector) <span class="tb_red">Note:Total maximum combined output is 25W (subject to input power limits). * Output Power Supply Topology: Fully isolated switched-mode power supply Maximum 25W (SMPS5V and 12V outputs cannot simultaneously achieve maximum current) topology</span>

* Single-Cable SolutionFully Isolated Power Supply: Delivers both power Utilises isolated Switching Mode Power Supply (SMPS) topology for safety and data to the CM5 through a single Ethernet cable.reliability

* Peripheral PowerSimplified Cabling: Provides a Single cable simultaneously addresses power delivery and network connectivity, providing robust, dedicated 12V output power for peripherals, eliminating the need for an additional external power supply.

| Power output || 5.1V 2.'''Maximum output current ''':- 5V / 5A - 12V / 12V 12.1A @  '''Actual available power depends on the PoE source ''': - IEEE 802.3afmode: approximately 12W 5.1V 5.0A / 12V 2.1A @ - IEEE 802.3atmode: approximately 25W 

| Ports & Connectors || 2x2pin POE female header x1'''PoE input interface''': 2x2Opin GPIO extended female 2x2-pin header x1

'''GPIO expansion interface''': 2x20-pin header x1 '''12V output interface''': 2-pin XH2.54 12V output connector x1

| Dimensions Dimension || 65×43.2×22.1mm (L×W×H)

* screw pack x1(for securing to IO Hat)

* Hardware Installation: https://suptronics.com/Raspberrypi/cm5/x15-poe1-v1.1_hardware.html