Raspberry Pi Model A+ 256M
Contents
Overview
Raspberry pi model A+ (256M) The Model A+ is the low-cost variant of the Raspberry Pi. It replaced the original Model A in November 2014. Compared to the Model A it has:
- More GPIO. The GPIO header has grown to 40 pins, while retaining the same pinout for the first 26 pins as the Model A and B.
- Micro SD. The old friction-fit SD card socket has been replaced with a much nicer push-push micro SD version.
- Lower power consumption. By replacing linear regulators with switching ones we’ve reduced power consumption by between 0.5W and 1W.
- Better audio. The audio circuit incorporates a dedicated low-noise power supply.
- Smaller, neater form factor. We’ve aligned the USB connector with the board edge, moved composite video onto the 3.5mm jack, and added four squarely-placed mounting holes. Model A+ is approximately 2cm shorter than the Model A.
We recommend the Model A+ for for embedded projects and projects which require very low power, and which do not require Ethernet or multiple USB ports.
Features
- Silicon manufacturer: Broadcom
- Core architecture: ARM11
- Silicon-core: BCM2835
- Bits: 32-bit
- 700MHz, VideoCore, IV, Multimedia, Co-processor, 256MB RAM, 1 x HDMI, 1 x USB Port
Document
Element version
RS version
Enable comment auto-refresher